Wacker Neuson Cub 200 Návod k obsluze stáhnout pdf (Strana 38)

Maintenance Cub 200/300/300 HD

wcghi_tx000721gb.fm 38

4.10 Inspecting the Flame Head

See Graphic: wcghi_gr004028

To inspect the flame head, carry out the following procedure:

4.10.1 Remove the burner assembly. See section Removing and Installing

the Burner Assembly.

4.10.2 Mark the location of the air lock sleeve (c) with a pencil.

4.10.3 Loosen the wing nut (b).

4.10.4 Loosen the four screws (a) that secure the flame head (d).

4.10.5 Turn the flame head (d) counter-clockwise and remove.

4.10.6 Inspect the flame head (d) for the following:

• Wear. Replace if necessary.

• Cleanliness. Clean the flame head if necessary.

• Thermal stress. Replace if necessary.

4.10.7 Re-install the flame head (d).

4.10.8 Position the air lock sleeve (c) at the marked location.

4.10.9 Tighten the wing nut (b).

4.10.10 Tighten the four screws (a).

4.10.11 Re-install the burner assembly. See section Removing and Installing

the Burner Assembly.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 49 50

Žádné komentáře

Wacker Neuson Cub 200 Návod k obsluze Strana 38